Chery Indonesia Recalls Omoda 5 After Axle Shaft Breaks in Malaysia
Jakarta (ANTARA) – Following an axle-shaft failure in Malaysia some time ago, Omoda 5 vehicles sold in Indonesia have also been included in a recall campaign.
Budi Darmawan Jantania, Vice Director of Chery Business Unit, told ANTARA that the campaign was a preventive measure in response to an issue reported outside Indonesia.
“We are taking preventive action for units involved in an incident outside Indonesia. Although there have been no reports in Indonesia, we are taking proactive steps,” Budi said in an electronic message on Tuesday.
The recall covers certain Omoda 5 Z and RZ variants with specific vehicle identification numbers (VINs) and a torsion-beam rear suspension system.
The inspection is intended to check the condition of the rear axle beam and replace the component if considered necessary.
He said the programme was part of the company’s efforts to improve product quality and after-sales service, while ensuring consumers receive transparent assistance.
Chery Indonesia launched the recall after consulting its global technical team. The step also follows an assessment of potential issues with similar components in international markets, although the company did not specify the countries or incidents behind that assessment.
Consumers can check whether their vehicle is covered by entering the VIN shown on its vehicle registration certificate (STNK) on Chery Indonesia’s official website.
Technicians will inspect the rear suspension component and carry out repairs or replacement where necessary, free of charge.
The inspection and any follow-up work are expected to take around two hours, depending on the vehicle’s condition and the technical findings.
Chery has also begun contacting owners of vehicles covered by the programme to help arrange inspections.
The company says the measure is intended to address potential problems with vehicle components before they pose a safety risk to users.
Before launching the campaign in Indonesia, the Chinese manufacturer also conducted a recall in its home market.
That campaign covered 53,882 Omoda 5 vehicles over a rear-axle welding defect that could cause a joint to fail and affect vehicle control.
According to CarNewsChina, vehicles requiring further inspection were manufactured between 6 June 2022 and 31 December 2023.
Registered under recall number S2026M0146V, the campaign took effect on 27 November 2026.
A manufacturing-process issue could result in inadequate fusion or incomplete penetration where the rear axle’s retaining arm connects to its sleeve.
The recall in China followed an incident in Malaysia on 6 October 2026.
Malaysia’s Road Transport Department subsequently suspended type approval for the model and temporarily halted new registrations while it conducted an investigation.
In Malaysia, 8,878 Omoda 5 C and H vehicles are to undergo further inspection free of charge, with components replaced if necessary.
This follows an earlier action in 2024, when Chery recalled 600 Omoda 5 vehicles in Malaysia after an incident involving a detached rear axle. The company attributed the issue to incorrect calibration of welding equipment after a welding tip had been replaced.
Source: jawawa.id (https://jawawa.id/newsitem/chery-indonesia-recalls-omoda-5-after-axle-shaft-breaks-in-malaysia-1794304279)
Originally published by Antara (Indonesian) (https://otomotif.antaranews.com/berita/5844103/chery-indonesia-recall-omoda-5-buntut-patahnya-as-roda-di-malaysia), translated from Indonesian